Categorized Tag Cloud

Please follow & like us :)

RSS
Follow by Email
Facebook
Twitter

Reinforcing Door and Door Frame Security

Reinforcing door and door frame security is a need because standard home construction methods, may not always protect entryways from forced entry adequately.

According to recent FBI statistics a home burglary occurs every  18 seconds. The most common method of entry is through an unlocked door. Next is forced entry usually via a simple kick-in attack.  Fortunately there are a number of relatively inexpensive do-it-yourself fixes. These devices when properly installed will greatly harden and reinforce entry doors, windows and door frames. The following video is very well done, it is a little long. But at end gives a very good demo how the product hardens and reinforces the entire entryway.

The Door Devil Product is available in our Security Store

First you need to be sure the door itself is adequate. Exterior doors should be constructed of solid wood, solid wood core, or reinforced metal. For this discussion the door going from an attached garage into your house will be considered an exterior door.

Modern home building utilizes many prefabricated parts, doors, door frames, windows etc. These prefabricated parts are then set into prepared openings. (See the illustration of a typical rough door opening). The focus is on the king and jack studs, these are usually 2-x-4 studs.

Typical door frame rough opening before Reinforcing door security

Typical door rough opening

A prefabricated door and frame will usually be inserted into that opening. The prefabricated frame is usually constructed of 1/2 inch thick by 6 inch wide jambs on each side and a header at the top. The installation of this prefabricated frame leaves up to a 1/2 inch of empty space between the back of the jamb and the face of the jack stud, (see door jamb detail illustration).

Door Jamb Detail- before reinforcing door security

Door Jamb Detail

The screws provided with most hinges and locksets are only 1/2 or 3/4 inches long. The end result is that all that is keeping the bad guys out is typically about 1 inch of 1/2 inch pine.

The minimum fix needed is to remove the short screws from both the lock strikes and the hinges. We recommend replacing them with 3 inch, or longer screws that will extend into the structural wood behind the frame.

There are many security products available that will provide even more security and strength to the typical door frame. Visit the Secureyourstuff Security Store for more information.

 

Please follow and like us:

Leave a Reply

You can use these HTML tags

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

  

  

  

Try Amazon Prime